Answer Posted / abdul
correct term is "Step potential"
It is voltage formed between legs when walking in a high
voltage area ie a substation. we have to make small steps
while walking in such substation yard. Lambs and small cows
usually kills when thy jumb.
Another term is "Touch potential"
This is also dangeorous. to reduse the risk, all substation
yards filled with stone metals.
| Is This Answer Correct ? | 4 Yes | 11 No |
Post New Answer View All Answers
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
How is the speed of a DC shunt motor related to the armature current?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
how many Classification of fire extinguisher
can i connect the two phases of scott connected transformer,if not why?
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
grr resistance & contrator malt continuous
how are reversing the direction of rotation of dc motor
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
Rules and standards of electrical control wiring ?
