Interested to Buy Any Domain ? << Click Here >> for more details...
What is the use of conservater, bucchos relay, breather in
a transformer?
- 8 Answers
- 27464 Views
- Bosch, Wipro, Zadco, I also Faced
- E-Mail Answers
Answer Posted / pria
buchholz relay is a gas actuated relay. due to fault, the
temperature of the transformer oil increases. as a result,
the oil vapourises and there is bubble formation. these
bubbles get acumulated on the rubber ball present inside
ths relay. as the viscosity of air bubbles is much lower
than that of oil, the ball moves lower and hence closes the
ckt for an alarm or trip ckt.
conservater: when the temp of oil increases, it expands and
hence increases the level of oil in the tank. the excess
oil goes to conservater.
breather: air enters the tank thro breather. but the should
not contain moisture as it reduces the dielectric strength
of the transformer oil. silica gel is used to absorb the
moisture. silica gel devoid of moisture is pink or white in
colour while wet silica is blue.
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
Explain in details how you would react to an unexpected incident when your supervisor or manager is not around to give instructions?
Iin ESP why positive is grounded ? why not negative ?
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
What are the main advantages of bode plot?
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
Explain the laying procedure and laying depth of submarine/subsea power cable for 220/400KV system? Also available cable diameter?
what is saturation kit?which use above 15 kw motors panel side.
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
When lag/lead/lag-lead compensation is employed?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
