Interested to Buy Any Domain ? << Click Here >> for more details...
why we use carbon brush in exciter&genrator?
- 5 Answers
- 11967 Views
- ABB, SMC, I also Faced
- E-Mail Answers
Answer Posted / sreeknp
normally brushes are of carbon it is a semiconductor its
resistance decreases with temperature, then self lubricant
this is the reason
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
what is the difference between the characteristics of two different phase bushing of any transformer
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
What is nichols chart?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
What is meant by harmonic distortion?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
How does PLC work for sychronising of Two or more DG sets?
what is the current density of copper & alluminium.
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
difference between a diode and thyristor?
how to calculate maximum current
