Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / omar aziz
Resistive or high impedance earthing is classified as IT
system in IEC standards. It is employed where there is a
need to limit the earth fault current to minimium levels.
Primary this id the grounding techinique used in coal
minning where high earth fault currents can lead to
catastrophic fires.
I hope this helps. If yourequire further info there is a
good technical paper on schnider website,
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
write down the formula of cable size in RM if current is 50Amp.
What happened when capacitor connect series in ac circuit?
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
How to determine alternating current frequency?
How to know the Max. current caring capacity of the cable by its size ?
what is auto re-closer?
What is difference between isolator and circuit breaker?
How to setting the volume of RTCC panel AVR (11kv) controller
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
What is “pu” in ee?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
IN dc capacitive reactance is??
