Answer Posted / nihar ranjan

Commonly 4 or 5 nos. appears in the bearing outer cage, The designation is for recognizing the type & size of bearing. e.g, 6305 .
1st two nos. 63 series used for deep groove ball bearing,
last two no. 05 for bearing bore size . But every time we need to multiple the no. by 5. So here in this case bearing size will be 05X5= 25 i,e 25 mm.
If there are any suffix , like RS or 2Z or Z ,etc then it is used for type of sealing used.
RS for rubber seal,
Z for metallic(one side)
2z for both side metallic.

Name the sheet metal hand tools?

1053

---

thermal engg

2051

---

why conservator contains 8% total oil qty in transformer any formula to calculate

2200

---

What is the most important, or helpful,project that you have contributed to?

980

---

On which analysis is based the dulong’s formula for the heating value of fuel ?

1144

---

How much should be the minimum and maximum suction and discharge pressure of screw chiller plant.

2768

---

Give one example each of the following proportion of materials dimensional, physical, technological and mechanical.

1092

---

if any one attended caterpillar placement pls send the model questions and the question pattern.....

2653

---

In General please do read newspapers.And be thorough with 10th history and Geography.Biology also

1981

---

What is IS standard in case of mode of measurement for ducting

2153

---

How to find the amount of natural gas required to produce 1kwhr of energy?

2319

---

composition of cast iron fc-500,fc-550,& fc-260 which is use in sheet metal industries as a piller set

3396

---

what is rolling margin?( from view of machining process ) explain briefly

1859

---

In Turbine how the balence piston works and what is the direction of leak of steam flow.

2983

---

What do you understand by critical points in iron, iron-carbide diagram ?

980

---