what is the difference between Feedback controller and Feed
forward controller. and when it is to be used.

Answer Posted / jai

feed back controller is slow response ,feed forward is fast
response loop,becuae we are measuring the process value
before the control element.we can use wher we required fast
response.actually both loop prsent in the case cad control.

Is This Answer Correct ?    27 Yes 5 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.

1594


How to Calibrate Radar Level Transmitter in Field

733


What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?

1641


When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

1399


what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.

2278






What is the use of control cable?

686


how to calculate signal cable sizing? and multipair cable sizing??explain in brief?

1899


why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.

2202


What is the purpose of bypass valve across AS valve.

1658


why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.

1933


why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??

6859


when a magnet is heated?

1521


what is function of SCADA , and how is it work, explain with difination

1831


What is zero elevation and zero suppression?

1610


What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem? 

2014