Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between PLC and SCADA
- 13 Answers
- 70019 Views
- Uflex, Vimal Fire Controls, I also Faced
- E-Mail Answers
Answer Posted / ankur kumar
Supervisory Control and Data Acquisition
Programmable logic control
| Is This Answer Correct ? | 121 Yes | 46 No |
Post New Answer View All Answers
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
what is meant by LCR meter? where its useful ?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
What is the selection process of breakers. Can any one please give a formulation on same?
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
What is mean by spike arrester(Voltage Operated)
What are the various types of BUSBAR Schemes? explain each
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv
What are the causes for the failures of sandwich type (Al) busducts?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is Antipumping Function & If we have C.T how we find the Ratio ?
can i connect the two phases of scott connected transformer,if not why?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
