What will happen if DC supply is given on the primary of a
transformer?
Answer Posted / naresh
we know that in case of a transformer ,the emf induced in
the secondary is proportional to the alternating flux
flowing in the primary of the transformer.
so alternating flux is produced by supplying alternating
voltage to the primary of the transformer.
if in case a dc voltage is applied ,the flux flowing
through the primary of the transformer remains constant.
therefore emf induced in the secondary is zero.
therefore no emf is induced in the coil.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what happen if the parallel generator phase angle shift by 1 degree in manual mode
How is operate breaker failure scheme in substation
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
what things to be considered when designing UPS
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
in shunt clippers why a resistor is used in sereis with the input
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
What is “pu” in ee?
define the non synchoronism of synchoronous machine in general g or m??
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
SUTIABLE FOR ohm's law super conductor