Interested to Buy Any Domain ? << Click Here >> for more details...
WHY POLARITY TEST OF CT IS VERY IMPORTANT IN SWITCHGEAR
- 3 Answers
- 20295 Views
- Birla, Reliance, I also Faced
- E-Mail Answers
Answer Posted / raghavendran.r
CT works on subtractive polarity.It is essential for
reducing the flux build up in the CT secondary, otherwise
immense flux build up will cause insulation burn out.Also
the CT secondary should not be left open.
The other power transformers work on additive polarity
principle.Hence it is required to check the polarity.
| Is This Answer Correct ? | 25 Yes | 10 No |
Post New Answer View All Answers
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Swg formulae
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
what is current check gurd relay?
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
what is the transformer turn ratio formula and give some examples?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
Show the schematic arrangement of diesel power station layout and give its principle of operation.
What is the formulae of Megger value for a A.C.Motor
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
How good are you in resolving the commercial issues to Employer's advantage?
