the question is about buchloz relay
why we called it buchloz relay
Answer Posted / rajesh
It is observed that people blindly mark the answers "yes"
or "NO". Therefore this system is not serving any purpose.
It will be better if a "reply" button is provided at the
bottom of the answer so that others can respond to it in a
meaningful way.
Also. it may be noted that "Is this answer correct" can not
be always answered in "yes" or "No". For example, refer the
ans #4 given above. You can not say that what is given in
the answer is wrong. The statement "It's a
gas operated relay,used for oil immersed
transformers...................transformer" is correct.But
it is not relevant to the question "Why we call it bucholz
relay?". The relevant answer is that it is named after the
inventor (as given in answer#3). These issues can be
brought out only when there is a reply button rather than
a "yes" or "no" button.
Unfortunately, I could not see a "contact us" menu for
giving this feedback. So, I am posting this as an answer.
Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
what is the meaning of vcc
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
how many stairs have you climbed while you were coming
what is the illumination level required for child play area?
how to calculate the loss tangent of electrical cables
What are the advantages of the three-phase motor over single phase motor?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
How much load can take a 16 mm aluminum cable 3 phase
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
What is Plank's Law?
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
how to calculate power consumption in slip ring motor at different step
why dimmerstate always connected in star connection? what will happen if it connected in delta?