Answer Posted / sithathur ramamoorthy
mono block,centrifugal type is best upto 35 feet.upto 100
feet jet pump is best at low cost.upto 450 feet
aircompressor or bore well submercible is best.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is CVT and what is relation with wave trap?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
How does an induction motor start?
THERMAL CAPACITANCE IS MEASURED IN..................................................
In dc ckt. 24v or 110v, which one is more efficient and why?
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).
what is zinc diffusion?
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
How to select HT/MV cable size ?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
