Answer Posted / prakash

As the cable size depends upon the current & voltage
ratings, you can use cable with appropriate voltage rating,
the size can be any,but not less than 150 Sq. mm.

hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused

2074

---

State ohm’s law?

1169

---

What is the mechanism of WTI

1844

---

how wecalculate breaking capcity of acb mcb mccb .explain with example

1989

---

What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.

8401

---

what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group

2134

---

what is the need of starter in tube light and what type of starter is used in that?

2094

---

if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?

1465

---

What is the minimum underground tank size capacity considered for firefighting purpose?

2005

---

How is the percentage impedence of a transformer fixed at design stage???

2022

---

Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet

2594

---

May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?

1554

---

Why single phase induction motors are not self starting ?

1706

---

what is mean by PIR in circuitbreaker and give me detail of that?

3575

---

how to find impedance , mutual indatnce in transmission lines

2378

---