Answer Posted / deepak
tx o/p limited by heating hence losses
and losses depend apn V, I only not on load pf
so rating in volt-amp.not in watt.watt mean active
powr depend apn pf also
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
please send me privious exam's queation papers of section engineer(electrical).
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
How to synchronization will be done between two DGs ?
how do you test tachos and servos
What's the difference between non break power supply and non break non short break power supply
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
What is called grain-oriented laminations?
How can we increase fuel-power ratio of any DG set?
Difference of induction motor & servo motor ??
Why the output of OP-AMP is always less than Vcc?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
Why earthing is necessary for any equipment?