Bus-bar is made of which material & name of mostly used
material in bas-bar design ?
Answer Posted / md imran
Bus-bar is made up of aluminium.
there are bus-bar is made of aluminium,copper.
| Is This Answer Correct ? | 37 Yes | 4 No |
Post New Answer View All Answers
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
how to calculation increase power factor for single phase
Electrical Engineering
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
What is open delta Xformer? It's adavntages & Use?
What is meant by reset level of the relay?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
what is the difference b/w UHVDC and HVDC(LIGHT)?
What is Bolted fault?
what are symmetrical and non symmetrical components in electrical installation.
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
working principle of AC Servo Motor with its construction