What is differential relay ? where it can be used?
- 1 Answers
- 4632 Views
- Scope International, I also Faced
- E-Mail Answers
Answer Posted / meenakshi
Differential relay is one that operates when the phasor
difference of two or more similar electrical quantities
exceed a predetermined value. Thus a current differential
relay is one that compares the current entering a section
of the system with current leaving the section.Under normal
operating conditions, the two currents are equal but as
soon as fault occurs, this condition no longer applies. The
difference between the incoming and outgoing currents is
arranged to flow through relay operating coil. If this
difference is equal to or grater than the pick up value the
relay will operate and open the circuit breaker and isolate
the faulty section.
mainly used in two winding transformers
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
What are the different sign conventions used in electric circuits?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
What is the distance between body earthing and neutral earthing.?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
how a flip flop can be used as a latch?
How can calculate the rating of a servo stabilizer for given a specific load
How to calculate Air conditioning capacity for a telecom BTS shelter?
how to extend relay operating timing in 24V dc relay card (without using Timer )
Explain about p.t?
what should be correct gas pressures to be a 1.5 ac unite
