What is surging in centrifugal compressor. how its happened
and how to avoid it.?
Answer Posted / mayur amipara
srging basically means reversal flow fluid from compressor
to evaporator...it occurs when the pressure is
increased.And to avoid this reversal flow a check valve
must be provided in the suction line.
Is This Answer Correct ? | 22 Yes | 43 No |
Post New Answer View All Answers
hi friends kumar here if anybody of u have essar placement papers than plz send it to me i need it urgently..ok mail id is kskalyani@gmail.com
SIR, PLZ GIVE ME INFROMATION FOR WRITTTEN TEST AND PI IN ISRO AHMEDABAD (MY MAIL ID:-ppdave@yahoo.com)
what will be the min curvature ratio for Round Bar dia. 1” size in material grade AISI 4330, Yield strength 115KSI Tensile 140KSI?
Why rockets using liquid hydrogen have higher specific impulse compared to liquid hydrocarbon ?
What do you mean by A.CC.?
What is the material used ball screw rod
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
What is the function of thermostat in cooling system of an engine ?
What is the flow of steam in an impulse turbine?
How can one estimate the flow from a centrifugal pump after an accident where the pipe attached to the pump discharge breaks? Extrapolate the characteristic pump curve to H=0?
how much efficiency loss will tool place in a steam turbine due to low vaccum?
can any body send me previous year model papers of BEL and BHEL PLZ mail to manume31@gmail.com
Draw the flow of F.O. diagram from service tank to Main Engine?
Effect of surface finsh & surface roughness on coefficent of friction in form press tools.