Interested to Buy Any Domain ? << Click Here >> for more details...
what is the CT of protection and CT of metering ? what is
class 5P10 & 5P20 and class PS ?
- 16 Answers
- 131716 Views
- JEE Main, ONGC, VRA, I also Faced
- E-Mail Answers
Answer Posted / ayub
THERE ARE TWO TYPE OF CT USED
1) METERING
2) PROTECTION
IN THE PROTECTION CTS
THERE SUB CT/S BASED ON THERE FUNTIONING
5P10, 5P20 & PS
FOR 5P10 CT : 5 % error in the ct for protection current
sensing/measurement
p: is used for Protection purpose
10 0r 20 : The ct will withstand 10 or 20 time current of
the rated primary current of the ct e.g
300/1 it mean the ct will with stand 3000A, for 1 minute
during the fault sensing current
| Is This Answer Correct ? | 57 Yes | 24 No |
Post New Answer View All Answers
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
hey guys help me out.....what are the industrial uses/functions of nozzles in industries
Keywords: Die, Card, Coin, B/N 2 To 12
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
How you give clearance to a spare feeder.
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
What are the advantages of the three-phase motor over single phase motor?
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
what is the difference between Central Battery System and UPS in applications and uses? and why UPS suitable for Computers and central battery for emergency lighting?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
