Answer Posted / mm
If we are talking about teh motor it self, then check teh
following,
1) while rotaing the shaft, the movement must be free and
there is no abnormal sound. It ensure that bearings are
fitted properly and rotor shaft is aligned.
2) Second check there is any play in the shaft by pushing
it forward backword or up-down. It will ensure that the
bearing housing is ok.
Then your motor is ready for installtion.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is a dc motor?
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
why single CT used in DOL starter power circuit?
State the frequency for rc phase shift oscillator?
why we use copper earthing for neutral while for body GI.
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
What are the advantages of hydropower?
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
Write a note on materials used as a fuse element.
Why to keep capacitor bank off while generator running.
what is v/f control in VFD?
Hoe do calculate the Cable size for Amps rating ?
Hello sir, pls send me hpcl technical test papers .i am. Appearing for the exam.
how brushed dc motor operating ?
What is depreciation factor?
