Interested to Buy Any Domain ? << Click Here >> for more details...
how does the switching of capacitors in a capacitor bank
take place when we use them at the load side to reduce the
power factor?
- 2 Answers
- 5149 Views
- I also Faced
- E-Mail Answers
Answer Posted / mpn
Switching is done by closing the apropriate contactor in
the circuit. Suppose you have a 30 KVAR capacitor bank, a
40 KVAR capacitor bank and a 50 KVAR capacitor bank. Each
will have a contactor in the circuit. If you want only the
30 KVAR capacitor bank in the circuit, you close only that
paricular contactor. If you want 90 KVAR, you close the
contactor for 40 KVAR and 50 KVAR banks.
Also, please note that there is a mistake in your question.
Nobody will use capacitor bank for reducing the pf. It is
used for improving the pf.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Why do we avoid electrical conduits in floors at apartments?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
explain different losses in a transformer.
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
WHY IS THE EARTH FAULT CURRENT ALWAYS LESS THAN THE NORMAL CURRENT??
What do you mean by lighting transformer?
A d.c. Shunt motor is found suitable to drive fans because they require?
why we change the direction of winding in rotor ?how we make the north and south pole?
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
