Answer Posted / rakesh mittal
pipe is identified by Nominal Bore & THIKNESS is defined by
schedule where as tube is identified by OD & thickness by
gauge
one more difference is dictated by the application.
Tubes are meant for both heat and mass transfer.(Because of
this finishing is different and dimension tolerances are
more accurate.)
Pipes on the other hand ,are for mass transfer.
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Dear friends, i am a student of mechanical final year in rajasthan. If you have any type (Technical,interview, aptitude) of question paper related to BIRLA CEMENT LTD. than plz send me these paper at vinodsainikumar4@gmail.com thanks
What are the uses of windmill?
"In boiler, what does steam and smoke goes out to the funnel. What reason?"
what's the difference between front and rear wheel drive?on what basis we choose the type of drive?
please send the last 5 years {{{JUNIOR ENGINEER GRADE II - MECHANICAL RRB CHENNAI}}} TECHNICAL question papers
What is the name of solid solution of carbon in alpha iron and delta iron ?
What is a uniformly distributed load?
Who built the trans alaska pipelene?
What are hydraulic and pneumatic machines?
What is the power requirement of a refrigerator?
how to select a pump (in hp) for lifting water from a Borewell upto a height of 320feet? Is there any thumb rule?
How can you identify mild steel, cast iron, and high carbon steel?
hi gys.. I too want sample papers of hpcl(mech) please help me......plz..... mail me dnaik2006@gmail.com
we need tech specs of HP fan cap 50,000 m3/Hr, Pressure o.5-0.7 Bar for blast furnace at steel plant
What is the purpose of air blow?