Answer Posted / shiddappa
static switch is an electronic switch that is usualy built
silicon controlled rectifiers or scrs
its use in ups systems
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
What are the differences between single phase and three phase?
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
if a.c supply is given to the motor,, what happen?
pls tell me function of closing coil of A.C.B.
Write the programming software name for LG, SIEMENS,Messung,AB
What is routh hurwitz stability criterion?
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
How will polarity test of Dy5 Transformer ?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
