Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ajith294
here more answers reagrading positioner
maximum of the answers are 'YES' especially Answer number
10,
then i have a doubt that how control a valve at 50% open,
with out a positioner.
if there is not a positioner, how we can control the valve
( control the pnumatic pressure is applied the
actuator)?????
if a valve it using fully open of fully close condtion
throgh Solenoid Valve ( bypass the air to actuator) is on
off valve.
Without a positioner we cannot control the valve through a
controller.
thanks
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
plz send me general of ongc
What is Cavitation in a control valve?
How r the calculation of process line mpm.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
what would be the minimum flow rate that we can measure on rotameter..?
what is SIL 1 2 3
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Programmable Logic control.
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
State bernoulli’s application.
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
How to Calibrate Ultrasonic flow Transmitter in Field
How to erection of DCS Panel at site step by step
What is first echo & echo window in radar type level transmitter?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
