Interested to Buy Any Domain ? << Click Here >> for more details...
what is the method to calculate the voltage drop for number
of meters Example 250volts I/p at one end if the cable
length is 50 meters what could be the drop?, after 100
meters how much? needs formulae.
- 1 Answers
- 4155 Views
- I also Faced
- E-Mail Answers
Answer Posted / raghavendran.r
The formula for the line voltage drop is
V = sqrt(3)*[I*L*{Rcos(phi)+Lsin(phi)}] for a three phase
system.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
how much excitation voltage required to generate 1mw power?
what is the use of expulsition protective gap in 11Kv line.
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
What happen to generator if i have unbalanced load?
What do you mean by dependent and independent voltage sources?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
how to calculate slip ring induction motor stator and rotor currents??
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
