Answer Posted / sathish n p
Transformer works om principle of MUTUAL INDUATION.
This can easily understand by this two laws.
1.PRODUCTION OF MAGNETIC FIELD WITH ELECTRIC CURRENT.
When an electric current flowing through any conductor it
not only produces heat but also magnetic filed arround the
wire & identified by placing needle near to the
condutcor.Intensity is increased by wound the wire in to
ring and amount of electric current flowing through the
wire.
2.PRODUCTION OF ELECTRIC CURRENT WITH MAGENTIC FIELD.
Whenever conductor is moving in the magentic field an EMF
will generated in the conductor and magnitude of the
voltage depends on the rate at which conductor moves..( DC
generator principle )
In primary winding magentic field is produced with the aid
of electric current whereas in the secondary winding
electric current ( EMF ) will produced with aid of magnetic
feild.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
What are approaches to tackle sedimentation problem of reservoir?
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
how many stairs have you climbed while you were coming
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
how does high earth to neutral voltage affects electronic circuit?
State ohm’s law?
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
along with technical test papers
why we are not giving the zone 1 trip command to the master trip relay
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
in shunt clippers why a resistor is used in sereis with the input
