Interested to Buy Any Domain ? << Click Here >> for more details...
what is transformer
- 63 Answers
- 81149 Views
- ABB, Advance Power Controls, CERC, Electrical, Electrical Supervisor Competency Certificate, ETA, IBM, Jindal, I also Faced
- E-Mail Answers
Answer Posted / nukman hakkim
transformer is a electrical static equipment,it transfer
energy to one electrical circuit to other electrical.
circuit(one circuit to other coil)with out changing frequency
it has a two winding primary winding and secondary winding
or(output and input)step up and step down voltage depending
up on the turns of coil.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
How do we calculate over and under frequency tolerance from generator data?
how does an centrifugal and screw type chiller will work. which chiller efficiency is high and why.
how we will deside the high voltage value
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
Briefly describe your ideal job?
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
The loads are connected with phase and ground then why current flow as the loads ?
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
electrical ques
how to setting voltage RTCC panel
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
