Interested to Buy Any Domain ? << Click Here >> for more details...
Electricty is generated at around 16kV, then step up to
220kV for transmission then steped down to power
transformers then DTs and then through the LT n/w it reaches
the consumer end.
At the consumer end 230V supply is required. So, why is
electricity not generated directly at 230V and transmitted?
- 4 Answers
- 7756 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil kumar verma
power is generated at power plants which are generally
situated at far distance from the actual users at 220
volts. so power has to be transmitted to these users. if
power is transmitted at 220 volts then due to high currents
at low voltage transmission losse will be very high & very
low voltage will be experienced at consumer end. so to
minimise the losses power is generated & transmitted at
high voltage. moreover generation & transmission at 220
volts will not be cost effective.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
How to discuss the phase shift of transformer considering open delta?
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
Is Transol transformer oil comparable to nynas nytro libra?
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
why tertiary winding is used in transformer with diagram?
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
Types of test in Switchgears, MCC, NGR and DB's how it should be procced. Can anyone give me the details here or email me to pasuvaraj.k@gmail.com
Where voltage are high and current to be interrupted is low the breaker preferred is:
What are the advantages and disadvantages of short-pitched winding?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
