Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raghavendran r
A decrease in Excitation Causes
1) Decrease in Terminal Voltage.
2) Increase in Stator Current.
3) Decrease in Power factor.
If further reduced, it might cause Pole slipping and Gen
coming out of synchronism.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Explain bypass capacitor?
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
How to back charge the Gas turbine generator
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
What is CCM in Electrical ? where can we use this material?
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
single phase power supply give to separate one steel coup with water, what reaction create
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
Why we use mho Relay in long transmission line?
AL=0B9H,bl=75H, ADD AL,BL AL=____________? CF________? OF___________?
Please send 110 kv sb station full single line drawing(sld)
