what is the difference between 5P20 class CT , PS Class CT
and 5P10 class CT??
Answer Posted / lim
PS the first time i know.
may be no 1 is 1% tolerence accuracy
i take the knowledge only.
Is This Answer Correct ? | 12 Yes | 68 No |
Post New Answer View All Answers
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
how many single tension hardware are required on a double circuit transmission tower?
internally connection of photvoltic module
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
How generating electric power export to grid from the generating station ?
Why do power lines not short out when they fall into water?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
Name two types of electrical analogous for mechanical system.
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
What are marginally stable systems?
what is effect of 5amp fuse on 2mva pry protection of transformer
What is a differential amplifier? Also, explain cmrr.
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
Why the output of OP-AMP is always less than Vcc?