what is the formula or method to calculate
RESIDENTIAL,COMMERCIAL & INDUSTRIAL load power?????
Answer Posted / m.kumaran
load power in residential,commercial,industrial are based upon 1.resistive load(lamp)
2.inductive load(motor)
3.capacitive load.(battery)
normally power in calculated from P=VI or P=I^2 R
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
Why generation voltage in thermal power plant is between 11kv to 33kv?
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
What does a Bode plot tell you?
How to measure current and voltage in an ELV circuit
how to select proper cable for ct wiring so that drop within the limit.
how rectifier transformer work in electroststic precipetatore(esp?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
What is DC series motor?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
How 48-relay (incomplete sequence) functions?