Answer Posted / sureshkumar.n-npr
This is normally PF mans cosine angle between used power.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
What is a difference between indoor transformer and outdoor transformer of same rating
how does it help for selection of a transformer.
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
What are the disadvantages of thermal power plant?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
I have finish diploma electronics and five years experience in electrical field in ht service how can i get c licensce or other electrical certificate
what is interfacing in computer studies?
how ceiling fan worked?
why using transformer and thyristor switch in 3 phase apfc panel
what curve and rateing would you use for a three phase 0.75kw motor?
whatis the commertial spec. of distribution boards ?
What is transformation ratio what it describes?
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.