Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mariappan k
increasing the frequency up to 400Hz,we can decrease the
size of transformer.we get 400hz by changing the poles in
generator also called rotary converter
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
What is the formula for calculating no-load current?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
What is resolver and glass scale in CNC how they work?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
what is the pre charge circuit,what will be work which function it will be use plz tell me
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
Why DG set is not installed in Terrace ??
why to use freewheeling diode ( diode in revers bias mode) across dc coil
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
Why reactors use before incoming of ac vvfd drive?
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
what happen if the parallel generator phase angle shift by 1 degree in manual mode
what is meant by impedance & transient protection?
