Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / m.kumaran
The power factor means the cosine angle between voltage and current
Power factor=VI COS0
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to read idmt curva
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
How does PLC work for sychronising of Two or more DG sets?
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
How to convert a two phase power into a three phase power in induction machine?
Please tell me the earthing procedures adopted for the STAR-STAR 3 Phase transformer in india and give a better sugession for earthing
What is difference between Harmonic and Non harmonic Capacitor Bank?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
Explain about c.t?
what is servo motor & how does it work.
what is high and low cut off voltage of BB and DG at SPS????????
what is the transiant condition in alternator? and how it can be prevanted?
what is the mechanical safety of DG ?
