Interested to Buy Any Domain ? << Click Here >> for more details...
what should be the distance of vibration sensor & to the
point where vibration to be measured Ex turbine axial
displacement
- 3 Answers
- 7875 Views
- I also Faced
- E-Mail Answers
Answer Posted / prakash
The philosophy is different for Axial and Radial
measurment. For radial measurement the AC component voltage
is directly proportional to the magniture of vibration so
the gap is fixed based on the probe linearity (usually
10vdc for bently nevada probes).
For axial measurement the AC component voltage is not
important and only the DC component is considered which
varies proportional to the distance between the probe and
the shaft. Conversely, the shaft is centered and the probe
voltage is adjujsted to 10Vdc and the same voltage is also
referenced in the system for shaft zero position. While the
unit/turbine is running the position of the shaft is
proportional to the dc component measured.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
What is three element drum level control system why its better than single element?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
What are different types of control valves?
how many type conductivity sensor ?
How it the difference between force balance system and dispalacement balance system?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what are the selections available in configuring a burnout protection of a controller? thanks
defination of radial vibration?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
what is the reason while warning lamp is on while the engine is cranking?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
what is basic difference between motion balance and force balance in pneumatic instrument?
what is exact time to study dcs and plc cources
