Answer Posted / jeet

generally tappings are provided on the HV side because on
the HV side of the transformer less current is flowing so
that whenever we change from one tapping to another less arc
will created as compared to LV side.Also due to less current better insulation can be provided.

how to design the heater in temperature control unit to heat 50KL of water?

1972

---

What is purpose of reactor?.What is different between line and bus reactor?

1991

---

why on delay timer used for fully automatic star delta starter?

1745

---

What are approaches to tackle sedimentation problem of reservoir?

1076

---

What is the end effect of linear induction motor ??

2074

---

What is difference between start imitation and start interlock for 3 phase motor protection ?

2306

---

with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....

2012

---

difference between crane drive and line drive.

1971

---

Define phase lag and phase lead?

1190

---

In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem

2016

---

Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?

1539

---

List of equipments required foe industrial repair lab.

1935

---

what happen when we add mentos in cold drink?& why?

2107

---

how to test the electrical panel.ht lt mcc pcc.

3842

---

if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm

2325

---