what will happen if dc motor given ac supply
- 11 Answers
- 37771 Views
- Mahaveer, I also Faced
- E-Mail Answers
Answer Posted / makga
is either you will distroy the motor and protection device
of DC and AC are not same. torque of ac is lower than of DC
motor. if you do that you will burn the motor
| Is This Answer Correct ? | 13 Yes | 4 No |
Post New Answer View All Answers
Why the power factor improvement is so important in industrial loads
how can motor both beasrings insulation resistance can be check?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
What is CCM in Electrical ? where can we use this material?
Why is water motor not taking the pressure? what is the problem?
how much leakage current is allowed in MC61A L&T make relay?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
What should be setting for alarm,tripping and cooling fan on for power transformer's oil temp. and winding temp. indicator?
What is the formula for calculating no-load current?
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
