i woule my experiences in BARC i recently gone for the
interview.. they dont consider u r dress code and all, even
u can go in a jeans and tea shirt.they dont careabout u r
personality , profile .. Theytest (complety) our technical
knowledge.. so u have to prepare well in not only the
basics but also in depth.. Even the did not consider the
percentile in GATE.. One guy got 99.63 in gate but did not
given medical. so u have to be very stiff and togh
technically.. u should have a lot of luck too,because right
panel selects u..
u dont expect what,how in Barc,only why.i amnot frightening
u, i am telling u some facts i have faced.. istead of all i
did it superbly and waiting for the result.. if u want more
information, u can email me ,call me at any time..
- 31 Answers
- 57896 Views
- Anil Group, BARC, HN, I also Faced
- E-Mail Answers
Answer Posted / sakshi sharma
Hii..
I have been selected for the interview for BARC DGFS/OCES
2010 through direct selection(through GATE scor).. I wanted
to know the pattern and what all is being questioned during
the interview.. I am in Computer Science stream. Please help
through it. I have my interview on 21st June,2010.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What are the causes of liner high temperature?
What are the causes of low compression in the main engine?
What is the purpose of increasing the pressure on the F.O. system of the engine?
What is "H7014C/HQ1P4 BEARING" means ???
sir i need section engineer test papers
What does a rolling offset look like?
How many 1.5 ton A/Cs can run on 7.5 kw generator (diesel)?
whether anyone has VEDANTA written question papers?if so send me soon i've placements in dec 2nd week
What is the difference between shear center flexural center of twist and elastic center?
i am from karnataka can i able to apply appsc
are BS, BSP, BSW threads same?
why conservator contains 8% total oil qty in transformer any formula to calculate
What are safety considerations in welding job?
How can I weld A234 WPB and WPB P11 fitting? Any special heat treatment required? What happen if I weld both?
What is max pressure?
