what is the function of potential transformer in s/s
- 6 Answers
- 35481 Views
- I also Faced
- E-Mail Answers
Answer Posted / umakanth kolluri
potential transformer is a step down transformer,used in
substations for metering purpose(to reduce the cost of
metering equipment for high voltages)
| Is This Answer Correct ? | 28 Yes | 8 No |
Post New Answer View All Answers
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
Define closed loop control system.
Can a generator runs after getting 1st stator earth fault.
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
what is resver in electrical enginnering with answer
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
how to find three phase complex power in per unit and MVA?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
If any cable burnt how can we identify it burnt by high current of high voltage?
what clearance required for 4.5 mva dry type transformer?
what is inverter and converter
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
Write down the name of 2 lady Bir Pratin of Bangladesh
Give two basic speed control scheme of dc shunt motor?
