Interested to Buy Any Domain ? << Click Here >> for more details...
how to install the Ph and Conductivity analyser? is there
are any procedures which has to be maintained.
- 2 Answers
- 5854 Views
- I also Faced
- E-Mail Answers
Answer Posted / rithesh
in horizontal or vertical pipe while installing we have to
take care about that it should be right angle to
pipe .there should be clearence of angle from sensor part
as specified by vender recomdetion.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
how to calibrate steam control valve in steam turbine
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
How is work 5/2 sov?
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
How we calculate orifice plat size???
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
What is the principle of capacitance type level transmitter?
What is motion balance principle?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
