Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / akshay
Just take a metal sheet with more than 5mm thickness, make
marking from where the sheet is to be folded, heat the area
by using gas cutter and bend at the marked area to 90
degree, you will get braket.
or
Mark the area by punch, cut it by gas cutter, finish it by
grinder and finally make a weld by taking required shape.
| Is This Answer Correct ? | 1 Yes | 15 No |
Post New Answer View All Answers
What will be the cause of the loose compression in a cylinder?
interview questiions for production planning
i want to know how a dg set run/works and what is strock and what difference in between two and four strock engine.
What is critical temperature in metals ?
How can i Check at site this material is Powder coated CRCA ?
Is the unit and normal value fuel ratio of an average diesel engine?
What are some mechanical laboratory apparatuses?
How with alloying of steel it is possible to a achieve properties which can not be achieved with heat treatment ?
What is polytropic process ? Under what conditions it approaches isobaric, isothermal, and isometric process ? In which reversible process no work is done ?
Whether entropy is intensive property or extensive property ?
hi sir would u plz kindly send me d previous years IOCL test papers......plz send it to this email id...jomygeorge787@hotmail.com
What parameters to be reported when we send lubricating oil for shore analysis?
What is a slined joint?
what is jdbc bridge?
how to minibar working
