what is the shuttering normal clear cover for footings,
walls, beams & columnms
Answer Posted / shiva
for footings 50mm
for columns 20mm
for beams and slabs 20mm
| Is This Answer Correct ? | 8 Yes | 24 No |
Post New Answer View All Answers
What is the primary difference between adsorption and absorption?
hoe much fine & sourse agregate required for concrete mix of 1: 1.5:3 by volume in Cu.Ft
I want to know the material required per square foot in rcc roof. i.e. steel: kg/foot, cement/foot etc.
How much river sand contain the 6 & 10 wheeler truck? Or Maximum sand that any type of truck carry?
the volume of cement req for 70cum of brickwork in 1:6 cement mortar is approx is equal to 3cum 5cum 7cum 1ocum
What is componsation
Find out Cutting Length of Steel for Right angle Triangle? Where Opposite Side 4m, Adjacent side 6m. (Assume cover 40mm)
For the construction project what capital cost has to be taken in consideration?
cement, sand, aggregate,reinforcement & concrete consumption per square feet in multi storeyed building
A sieve analysis results in 100% retained in no. 50 Sieve, the fm is?
What are the uses of alloys in daily life and how are alloys made?
For The preparation of goverment examination Which book i will prefer and by which way i will do the preparation for exam.
What is the difference between yeild strength and compressive strength of steel???
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
Explain the term 'Gross unit rate' and identify the items that may be included in the gross unit rate.