how to calculate the steel quantity for beams & columns
also footing net?
what is the formulae for calculate the steel quantity?
what is mean by (100.3)plinth level?what is mean by 100.3?
explained it?
- 3 Answers
- 18571 Views
- I also Faced
- E-Mail Answers
Answer Posted / sachin
TO calculate the steel qty first calculate the length of
steel as per drwg and multiply this length of steel to the
per meter wt. of the respective dia of steel. THIS GIVES
THE WT. OF STEEL IN KG.
100.3 plinth level indicates the RL of the plinth beam with
respect to the BM fixed for the plot plan.
| Is This Answer Correct ? | 32 Yes | 10 No |
Post New Answer View All Answers
How much permissible bearing capacity requires for open footings(isolated) and what type pile foundatuon prefering for coastal areas?
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
If we buy crush sand for 3200/ Brass and cement for Rs350 /Bag and flyash 1200 / tonne....and my production is 230 Bricks per bag than how much cost is required for 1 flyash brick?
how to balance aggregate during mix design of concrete???? how to calculate moisture content like C/A,F/A and how many percentage using ice instead of water for example of we are preparing ice concrete??????
what is mean by reestimation?
How is calculate the cube molt
At what point does a circle start losing area when being flattened?
what is tension footing?
what is the soil bearing capacity for a 5 floor multistorey residential building and which type of soil ? what is plinth beam? in wall load calculation center to center column distance is considered or not/
What are the applications of modulus of elasticity?
usually hand broken stones are used for cement concrete 1:4:8 in foundation of single /two story houses with a view of economy in construction.what advantages it will give if you use machine crushed stone in place?
Scaffolding IS code NO.
How to construct a water sump in a rocky soil?
What is the use of offset command?
What is absolute coordinates?
