Interested to Buy Any Domain ? << Click Here >> for more details...
Why in TV transmission amplitude modulation is used for
Video and FM for Audio. Is is possible FM for Video
transmission
- 8 Answers
- 35474 Views
- Sail, I also Faced
- E-Mail Answers
Answer Posted / anand
No,FM is't possible for video,Just amplitude modulation uses for the video,there are in a tube there are the two frequency receiver altar high and the lower and both are depends in intermediate Frequency which is received by Yagiuda Antenna.
| Is This Answer Correct ? | 5 Yes | 18 No |
Post New Answer View All Answers
SIR CAN U GIV TOPICS TAT COVERED IN JR.EXECUTIVE (ELECTRONICS) INTERVIEW N ALSO TIPS TO CRACK THE INTERVIEW PLZ
What is the protocol ?
Explain capacitance?
what is the minimum and maximam trace width in PCB design? why trace is measured in mils? what is the use of via? why the crystal oscillator is placed near chip?
What is the purpose of bleeder resistance in a rectifier circuit using l-c filter?
i am electronics & comm engg & appling 4 the AAI jr executive (electronics/ATC) written test. pls forward me the syllabus & old question papers.I will be very much thankful to you akil403@yahoo.com
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
What problem arise if we use regulators without/before filters?
why 8052 is preferred instead of ARM processors for soe applications
What is the condition to be satisfied in the selection of l and c in a series inverter?
what is the value of TEI ist T1?
Which was intel's first microprocessor
The output of the rectifier pulsating in nature, it consists of a desired dc component of voltage and unwanted ripple components. These ripple components are removed by placing filter circuit at the output of the rectifier.
Draw vi characteristics of pn junction diode.
When do we need drive test?
