A solid body of weight W is placed in a pipe. Suppose
water is started flowing through the pipe.what will happen
to the body. when it will start flowing ?
- 11 Answers
- 12041 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / pranab
As far as I am consider the weight will start flowing at
that time when the pressure of the flowing fluid exceeds
the resisting capacity of the body i.e.. the body will
first obstruct the flow upto the point when the flowing
fluid pressure exceeds the body resistence
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
i have been selected for the HAL interview? what type of questions can i expect? technical or personal? pls help me in this regard and mail to sankar_aji@yahoo.co.in
Explain the difference between pipe and a tube.
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
how a cyclone steam separator works?
On which analysis is based the dulong’s formula for the heating value of fuel ?
What is the difference between newtonian and non-newtonian fluids?
How can be calculate discharge of id fan. impeller dia-800 mm,motor capacity 10 hp 2800 rpm,blower opening section 230*130 mm
How should I begin a conversation that I need a change in the job to a known person in his organisation?
why there was 17 stage of compressor in the most of the gas turbine . depending on what?
Dear Sir, i need previous technical question papers, if possible so please tell from where i got these papers.
Please anyone send me previous papers of ONGC (Mechanical Engineering) at my email id jtndrkmr.vermaapril@gmail.com. Please help me.
in regenrative cycle why to use two liquid(water&mercury) on steam genration cycle.
What parameters to be reported when we send lubricating oil for shore analysis?
what is Retainer?
Why are lng pipes curved?
