Interested to Buy Any Domain ? << Click Here >> for more details...
What is IDMT relay how it works.
- 3 Answers
- 89857 Views
- Electrotherm, Sulzer, I also Faced
- E-Mail Answers
Answer Posted / hebson ombati
the inverse definate minimum time comprises of upper and
lower electromagnets.it have two windings primary which is
connected to current Tx and seconary.due to induction the
secondary is energised hence setting aflux .the leakage
flux from the upper magnet entering the disc have been
displaced in phase from the disc from the lower magnet. The
deflecting torque is produced on the disc in the fashion as
already explained.
The spindle of the disc carries a moving contact which
bridges two fixed contacts after the disc has rotated
through a certain angleThe speed of rotation of the disc is
dependent upon the angle the torque which in turn is
dependent on the current setting,
when the load current increases from this setting it will
increase the speed of rotation of the disc resulting into
decrease of operation time.
| Is This Answer Correct ? | 49 Yes | 9 No |
Post New Answer View All Answers
how to calculate current and voltage in a same circuit?
What is Load sharing of Transformer ?
What are the advantages of autotransformer?
How to test Alternator stability test for REF relay
Difference of induction motor & servo motor ??
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
What is the role of power pack in substation protection system?
what could be the RMS value and average value of a 4 phase sine wave?
CAN U PLEASE TELL ME SOME G.D TOPICS FOR APGENCO INTERVIEW&G.D
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
what is fault level of power system ?
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
