in india why 50 hz and 220 volt taken as standard rating for
equipments whereas in US 100hz and 110v is consided as
standard rating.is this method save power.
- 5 Answers
- 8505 Views
- Wipro, I also Faced
- E-Mail Answers
Answer Posted / saravanan
india power generation eqpiments rating standard is 50 Hz,&
220v (single phase).in us system is 100Hz & 110v. in this
method no save power
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
brief notes on ammeters
what is relay what is protection & contact multiplying relays where it is used function in brief
what is the importance of Partial Dischage test for Electrical Equipments
why the NGR (neutral grounding resistor) always OFF during DG off?
How does PLC work for sychronising of Two or more DG sets?
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
What is meant by system?
Why synchorised generators are used for the production of electricity?
what is the use of vcb & isolator in substation?
what is transient voltage?
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
