Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculated +ve & -ve Bending moment coefficient in
water tank design for design of side walls.
- 3 Answers
- 11087 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.dhinakaran
Its Purely Based on the support condition and Type of the
wall(i.e Fixed condition)
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????
How to construct a water sump in a rocky soil?
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
In the present situation of ban on mining sand from rivers,can we go for formation of earth dam filters viz;Horizantal sand blanket,inclined chimney and filters under rivetment with crushed rock sand of 6mm down size.If so what are the specifications and is there any codal provision for its authentication?
Why are pull-out tests performed for soil nails?
What do you mean by tolerance factor of concrete ?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
how much repeitation for conventional and maivan formwork?
undistributed samples are obtained by
where can i get the previous question papers for rrb section enginerr (civil)
what is the design procedure for building
Bernaullis theorem deals with the law of conservation of mass momentum energy none
what is the name of shuttering oil used in oman
400 ku d/c clearess ketan hota hai?
which software is better for design and analysis of buildings (stadd pro ) or (Etabs)
