Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dubai
As said by praveen, i would like to add one point to this
answer.
0-10 volt is an analog value which is first converted to
digital value via A/D convertor in PLC analog input module
& then D/A conversion is done by converting to 4-20 mA.This
is known as analog scaling.
Transducers are used as analog input device.They have zero
& span setting which scales the value as :
0 V=4 mA
10 V=20 mA
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is vaccum currcuit breaker.define with cause and where be use it device?
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
why should the primary of transformer be connected in delta in a heat run test?
Draw the line diagram of diffretial relay connected to transformer?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
What is an automatic controller?
Why efficiency of generator is higher than motor at a particular load?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
How To increase Knowledge Of boliler regarding To Only Electrical Field..
Benifits of 3ph 4 wire metering over 3ph 3 wire
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
differnce between single acting and double acting solenoid valves
