what is the role of electrical engineer in auto mobile
industry,whether there is good future is there
- 5 Answers
- 28823 Views
- I also Faced
- E-Mail Answers
Answer Posted / nasrath ali
In my pt of view der wil be lot more oppurtunities iin
automobile industry. Bcos automobile industry s heading
towards automation. so electrical engineers are very much
suitable to fulfil industry's needs
| Is This Answer Correct ? | 34 Yes | 7 No |
Post New Answer View All Answers
In a synchromesh device, when members G1 and F1 are slid to left and cones M1 and M2 are in contact, a) Direct gear is obtained b) Second gear is obtained c) Third gear is obtained d) Reverse gear is obtained
Do the design & fittings depend on the type of the vehicle engine? Why is petrol used for engines only & vice versa.
The maximum amount of axial load to be applied on a clutch plate is a) 100 KN b) 200 KN c) 300 KN d) 400 KN
Double declutching is used for the engagement of gears in a) Sliding mesh type of gear box b) Constant mesh type of gear box c) Synchromesh type of gear box d) None of the above
What are the different types of fits?
Why front wheel is bigger than rear wheel in tractor?
What do you mean by tempering?
Propeller shaft is used for the purpose of a) Transmitting the drive from the transmission to the bevel pinion of the final drive b) Transmitting the drive from the crankshaft to the road wheels c) Transmitting the drive from the transmission to the road wheels d) Transmitting the drive from the crankshaft to the bevel pinion of the final drive
1 TO 65
State two to three differences between two stroke and four stroke engine?
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
Why oil is mixed with coolant and what are causes of this?
Differentiate between two stroke engines four stroke engines.
The torque transmitted by a clutch is given by a) T = μWR b) T = μ/WR c) T = μW/R d) T = 1/μWR
Which conduct faster heat among steel, copper and brass?
