Interested to Buy Any Domain ? << Click Here >> for more details...
what are the pinciples & units of flow, level, temperature,
pressure, quality.
- 1 Answers
- 12093 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohammad reyaz ansari
Unit of flow:kg / hr, litter / min, gallon / min, m3 / hr,
Nm3 / hr. (Gases)
Unit of level: Meters, mm, cm, percentage.
Unit of temerature: Degree Centigrade, Degree Fahrenheit,
Degree Kelvin, Degree Rankin.
Unit of pressure: bar, Pascal, kg/cm2, mm Wg, mm hg,
| Is This Answer Correct ? | 21 Yes | 6 No |
Post New Answer View All Answers
Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Draw a great bridge circuit.
How does your previous experience relate to the job you are applying for ?
please tel me the calibration of pneumatic controler.
Gas equation
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
How d.p. Transmitter can be applied to close tank?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what about your moleg in pogrees with company
