Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between plc and pc?
- 5 Answers
- 37525 Views
- ADI, NFCL, Wipro, I also Faced
- E-Mail Answers
Answer Posted / vikash rawat
plc have no seperate memory and pc have seperate memory
| Is This Answer Correct ? | 26 Yes | 28 No |
Post New Answer View All Answers
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
can you send remote seal interface level transmitter calculation steps for oil water saperator.
Please asked me How calculate DCS controller memory.
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
In turbine what does term CDP, NI, NH, HSSOC means.
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
whats the abbreviation of IOP? is it instrument of power or input open problem?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
